some time, all the vtp domain and pass is match , but you still get error message like
*** MD5 digest checksum mismatch on trunk:
solution: on server switch, create a vlan, could fix the problem
or you can try change server to client mode then back to server.
Subscribe to:
Post Comments (Atom)
How to use Telus Actionec T3200M as a wireless Access point
when you install Telus Internet, they will offer you a modem + router + wireless device Actionec T3200M, a lot of users still want to use th...
-
when you updated your firmware of fortigate or setup new sslvpn, if you are using certificate other than factory default you might have is...
-
Installing or Upgrading HostScan Use this procedure to upload, or upgrade, and enable a new HostScan image on the ASA. Use the image to ...
-
Reboot the switch. You will see a prompt during boot right after the cisco logo made out of #s that says "Autoboot in 2 seconds - p...
No comments:
Post a Comment