you might see this error when you are doing VPN client installation
"VPN Agent Service not responding"
when you check the status of network adapter, the VPN adapter is disabled, and after you enable it, then doing installation, same error and the adapter has been disabled again, what is the problem?
1. you might have more than one anyconnect clients been installed.
2. you might have internet sharing enabled
solutions:
1. disable the internet sharing
2. uninstall all vpn clients and reboot computer then re-install.
Subscribe to:
Post Comments (Atom)
-
when you updated your firmware of fortigate or setup new sslvpn, if you are using certificate other than factory default you might have is...
-
Installing or Upgrading HostScan Use this procedure to upload, or upgrade, and enable a new HostScan image on the ASA. Use the image to ...
-
Reboot the switch. You will see a prompt during boot right after the cisco logo made out of #s that says "Autoboot in 2 seconds - p...
No comments:
Post a Comment