Monday, November 12, 2012
bgp community
r4(config)#route-map com permit 10
r4(config-route-map)#match ip address
r4(config-route-map)#set community 123
r4(config-route-map)#exit
r4(config)#route-map com permit 20
r4(config-route-map)#exit
r4(config)#router bgp 4
r4(config-router)#neighbor 5.5.5.5 route-map com out
r4(config-router)#neighbor 5.5.5.5 send-community
r5(config)#ip community-list 5 permit 123
r5(config)#route-map wei permit 10
r5(config-route-map)#match community 5
r5(config-route-map)#set weight 123
r5(config-route-map)#exit
r5(config)#route-map wei permit 20
r5(config-route-map)#exit
Subscribe to:
Post Comments (Atom)
How to use Telus Actionec T3200M as a wireless Access point
when you install Telus Internet, they will offer you a modem + router + wireless device Actionec T3200M, a lot of users still want to use th...
-
when you updated your firmware of fortigate or setup new sslvpn, if you are using certificate other than factory default you might have is...
-
Installing or Upgrading HostScan Use this procedure to upload, or upgrade, and enable a new HostScan image on the ASA. Use the image to ...
-
Reboot the switch. You will see a prompt during boot right after the cisco logo made out of #s that says "Autoboot in 2 seconds - p...
No comments:
Post a Comment